Re: Exhaust Back Presure

From: [email protected]
Date: 7/03/98
Time: 10:53:24
Remote Name: 194.168.58.203

Comments

Does it go o.k.? If it does - leave it alone. What needle and spring do you have? A good starting point is a No. 6 and a blue spring. Set up the mixture with a Colortune if you can get hold of one. I did but it popped on the overrun as it was too weak and it blew a 7" hole in the silencer. If it pops richen it one flat at a time till its stops. (popping that is!). The fishtail looks good and I use it for shows, but it restricts mine, take it off and it pulls better low down. Long inlets with SUs seem to suffer from icing, mine has no power below 2500 rpm until its really warm outside (about 20 Deg +). This dos'ent happen very often here! So I am thinking of some kind of a hot-spot or lagging. Good luck, Barry


The Austin Seven Motoring Pages