From: IAN MOORCRAFT(UK)[email protected]
Date: 12 Nov 2002
Time: 05:55:10
Remote Name: 62.7.80.32
Yes you are right about the alloy handle not being removable! As a rough guide to get the idea of the missing parts, you should have a steel pressing about 5x3 inches which bolts into the rear of the front cross member on the top of this is a brass adjuster which the cable goes around, the lever bolts on the drivers side of this setup, the ratchet is bolted to a fitting which is bolted into the rear of the gearbox. If you still cannot get a picture email me with your chassis no. and I will photocopy my parts list for you. Do you have the right gearbox with the "growout" on the o/s of the case to take the ratchet fitting? Regards Ian